D-Link DGS-3620-28PC-SI Product Manual page 303

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Profile ID (1-5)
Select ACL Type
802.1Q VLAN
IPv4 DSCP
Source IP Mask
Destination IP Mask
Protocol
Figure 7-29 Add CPU ACL Profile (IPv4 ACL)
Description
Enter a unique identifier number for this profile set. This value can be set from 1 to 5.
Select profile based on Ethernet (MAC Address), IPv4 address, IPv6 address, or
packet content mask. This will change the menu according to the requirements for the
type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
Select IPv4 to instruct the Switch to examine the IP address in each frame's header.
Select IPv6 to instruct the Switch to examine the IP address in each frame's header.
Select Packet Content Mask to specify a mask to hide the content of the packet
header.
Selecting this option instructs the Switch to examine the VLAN part of each packet
header and use this as the, or part of the criterion for forwarding.
Selecting this option instructs the Switch to examine the DiffServ Code part of each
packet header and use this as the, or part of the criterion for forwarding.
Enter an IP address mask for the source IP address, e.g. 255.255.255.255.
Enter an IP address mask for the destination IP address, e.g. 255.255.255.255.
Selecting this option instructs the Switch to examine the protocol type value in each
frame's header. You must then specify what protocol(s) to include according to the
following guidelines:
Select ICMP to instruct the Switch to examine the Internet Control Message Protocol
(ICMP) field in each frame's header.
293