Dhcp/Bootp Relay Interface Settings - D-Link xStack DES-3526DC User Manual

xStack DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual

DHCP/BOOTP Relay Interface Settings

The DHCP/ BOOTP Relay Interface Settings allow the user to set up a server, by IP address, for relaying DHCP/ BOOTP
information to the Switch. The user may enter a previously configured IP interface on the Switch that will be connected directly to
the DHCP/BOOTP server using the following window. Properly configured settings will be displayed in the BOOTP Relay
Table at the bottom of the following window, once the user clicks the Add button under the Apply heading. The user may add up
to four server IPs per IP interface on the Switch. Entries may be deleted by clicking it's corresponding
configure DHCP/BOOTP Relay Global Settings on the Switch, click Configuration > Layer 3 Networking > DHCP/BOOTP
Relay > DHCP/BOOTP Relay Interface Settings:
Figure 6- 109. DHCP/BOOTP Relay Interface Settings and DHCP/BOOTP Relay Interface Table window
The following parameters may be configured or viewed.
Parameter
Interface
Server IP
Description
The IP interface on the Switch that will be connected directly to the Server.
Enter the IP address of the DHCP/BOOTP server. Up to four server IPs can be configured
per IP Interface
123
. To enable and