D-Link xStack DES-3526DC User Manual page 111

xStack DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Figure 6- 76. CPU Interface filtering rule Configuration window for Ethernet
To set the CPU Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters
Profile ID
Mode
Access ID
Type
VLAN Name
Source MAC
Destination MAC
802.1P (0-7)
Ethernet Type
To view the settings of a previously configured rule, click
screen:
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Type in a unique identifier number for this access and priority. This value can be set from 1 -
65535.
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
•
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
Allows the entry of a name for a previously configured VLAN.
Source MAC Address - Enter a MAC Address for the source MAC address.
Destination MAC Address - Enter a MAC Address mask for the destination MAC address.
Enter a value from 0-7 to specify that the access profile will apply only to packets with this
802.1p priority value.
Specifies that the access profile will apply only to packets with this hexadecimal 802.1Q
Ethernet type value (hex 0x0-0xffff) in the packet header. The Ethernet type value may be
set in the form: hex 0x0-0xffff, which means the user may choose any combination of letters
and numbers ranging from a-f and from 0-9999.
in the CPU Interface Filtering Rule Table to view the following
97