Web-Based Switch Configuration; Introduction; Login To Web Manager - D-Link xStack DES-3526DC User Manual

xStack DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual

Web-based Switch Configuration

Introduction

Login to Web manager

Web-Based User Interface
Basic Setup
Reboot
Basic Switch Setup
Network Management
Switch Utilities
Network Monitoring
IGMP Snooping Status
Introduction
All software functions of the DES-3500 Series switches can be managed, configured and monitored via the embedded web-based
(HTML) interface. The Switch can be managed from remote stations anywhere on the network through a standard browser such as
Opera, Netscape Navigator/Communicator, or Microsoft Internet Explorer. The browser acts as a universal access tool and can
communicate directly with the Switch using the HTTP protocol.
The Web-based management module and the Console program (and Telnet) are different ways to access the same internal
switching software and configure it. Thus, all settings encountered in web-based management are the same as those found in the
console program.
Login to Web Manager
To begin managing your Switch, simply run the browser you have installed on your computer and point it to the IP address you
have defined for the device. The URL in the address bar should read something like: http://123.123.123.123, where the numbers
123 represent the IP address of the Switch.
In the page that opens, click on the Login to make a setup button:
This opens the management module's user authentication window, as seen below.
NOTE: The Factory default IP address for the Switch is 10.90.90.90.
Figure 5- 1. Login hyperlink
Section 5
22