Basic Port Port Maintenance; The Id Window - HP 400338-001 - KVM Switch Owner's Manual

Rackmount Console Switch Owner's Manual
Basic Port
Maintenance
Basic Port Maintenance is performed from the Administrator Command Menu,
and is available if you are operating in non-secure mode or if you are the system
administrator. Here you can add, delete or edit ports.
Adding Ports
1. Select 'Add Port' from the Administrator Command Menu or press the
2. Type in the address for the server you are naming and press Enter. Please
3. Enter the dwell time for the ID Window and press Enter.
4. Enter the dwell time for scanning and press Enter.
5. After selecting "ID Setup", use the arrow keys to position the ID window to
Press Esc at any point to exit this operation without adding the port.
20
Insert key. Type in a new port name, up to 14 characters long, and
press Enter.
note that the address cannot be longer than two digits.
where you would like it to appear when this port is selected. Then press Enter.
(For further information see 'The ID Window' later in this chapter.)
Hewlett Packard Console Switch
Add Port
Name
Address
ID Dwell Time
Scan Dwell Time
ID Setup
Save Changes
ENTER = save ESC = exit
THE ADD PORT WINDOW
5
5
www.hp.com/racksolutions