Front I/O Device
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
Unplug the audio cable from the yellow system board connector labeled F_AUDIO.
6.
Unplug the USB cable from the white system board connector labeled F_USB1.
7.
Rotate the drive cage back down.
8.
Remove the screw that secures the front I/O device to the chassis (1).
9.
Rotate the assembly toward the right side of the chassis (2), and then slide the device slightly
toward the left (3) to disengage the tab on the right side of the assembly from the chassis. Thread
the wires through the hole in the chassis and remove the assembly.
NOTE:
through.
To install the front I/O device, reverse the removal procedures.
114 Chapter 8 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Access Panel on page
(Front Bezel on page
If necessary, rotate the drive cage back up to better access the hole you thread the cables
(Preparation for Disassembly on page
84).
85).
83).