Access Panel - HP dx2810 - Microtower PC Service & Reference Manual
Service reference guide: hp compaq dx2810 and dx2818 business pc and dx2810 small form factor business pc
Hide thumbs
Also See for dx2810 - Microtower PC:
- Hardware reference manual (57 pages) ,
- Quickspecs (39 pages) ,
- Product end-of-life disassembly instructions (8 pages)
Table of Contents
Advertisement
Access Panel
NOTE:
The appearance of the power supply varies based on model.
1.
Prepare the computer for disassembly
2.
Loosen the captive thumbscrew (1) that secures the access panel to the computer chassis.
3.
Slide the access panel back (2) about 1.3 cm (1/2 inch), then lift it off the unit.
NOTE:
with the access panel is facing up.
Figure 7-3
NOTE:
If the access panel is removed while power is still supplied to the computer, the hood sensor
will sound an alarm. If the alarm sounds, unplug the computer and leave it unplugged until the access
panel is replaced.
To replace the access panel, reverse the removal steps.
38
Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
You may want to lay the computer on its side to install internal parts. Be sure the side
Removing the Computer Access Panel
(Preparation for Disassembly on page
37).
Advertisement
Table of Contents
