Hood Sensor - HP dx2810 - Microtower PC Service & Reference Manual
Service reference guide: hp compaq dx2810 and dx2818 business pc and dx2810 small form factor business pc
Hide thumbs
Also See for dx2810 - Microtower PC:
- Hardware reference manual (57 pages) ,
- Quickspecs (39 pages) ,
- Product end-of-life disassembly instructions (8 pages)
Table of Contents
Advertisement
Hood Sensor
If the access panel is removed while there is still power to the computer, the hood sensor will cause the
system to stop and display the Error 912 message after system reboot and will beep 5 times for 5
seconds. If the alarm sounds, close the access panel, tighten the thumbscrew, then reboot the system.
The system will enter the operating system successfully. If the error message persists, press the
F10
key immediately when the HP Logo screen is displayed to enter the Computer Setup menu. In the menu,
select Advanced > Hood Sensor > Reset Case Open Status and make sure Enable is selected, then
press the
F10
key to Save and Exit, then reboot the system.
Installing a Security Lock
81
Advertisement
Table of Contents
