Known APs Window
The
window displays the APs in range using the same ESSID as the device. This window is only
Known APs
available in
Infrastructure
window.
Known APs Window
Figure C-39
See
Table C-23
for the definitions of the icons next to the AP.
Current Profile Window
Table C-23
Icon
The AP is the associated access point, and is set to mandatory.
The AP is the associated access point, but is not set to mandatory.
The device is not associated to this AP, but the AP is set as mandatory.
The device is not associated to this AP, and AP is not set as mandatory.
Tap and hold on an AP to display a pop-up menu with the following options:
Select
to prohibit the device from associating with a different AP. The letter
Set Mandatory
icon. The device connects to the selected AP and never roams until:
You select
•
Set Roaming.
You select
•
Set Mandatory
You manually connect to a profile from the
•
•
The device roams to a new profile.
•
The device resumes after being suspended.
•
The device resets (warm or cold).
Select
to allow the device to roam to any AP with a better signal. These settings are temporary and
Set Roaming
never saved to the registry.
Tap
to update the list of the APs with the same ESSID.
Refresh
mode. To open the
Known APs
on a different AP.
Manage Profiles
MK2290 RF Network Configuration C - 45
window, tap
Known APs
Description
Set Mandatory
page.
in the
Wireless Diagnostics
and
.
Set Roaming
displays on top of the
M