Installing/Removing The Rf Card - Motorola MK2200-0N0SCKBWT0R - Micro Kiosk MK2200 Product Reference Manual

Installing/Removing the RF Card

T
NOTE his section applies to factory-shipped RF models only.
To remove and re-install the RF card:
Disconnect power from the MK22X0.
1.
Gently place the MK22X0 face down on a flat surface, using care not to damage the touch panel display.
2.
Remove the PCMCIA access cover.
3.
PCMCIA Access Cover
MK22X0 Rear View
Figure 2-15
CAUTION
Press the ejector button and remove the RF card.
4.
Ejector button
Removing the RF Card from the MK22X0
Figure 2-16
Insert the RF card.
5.
Re-install the PCMCIA access cover.
6.
When removing an access cover, follow proper ESD precautions to avoid damaging sensitive
components. These precautions include, but are not limited to, working on an ESD mat and ensuring
that the operator is properly grounded. Failure to apply proper ESD precautions can damage the
MK22X0 and void the warranty.
Installation 2 - 19