Aegis Client; Persisting Aegis Settings - Motorola MK2200-0N0SCKBWT0R - Micro Kiosk MK2200 Product Reference Manual

B - 2 MK22X0 Series MicroKiosk for CE .NET 4.2 Product Reference Guide

Aegis Client

Install the Aegis Client included in the platform partition 2250c42Plat64Mxxx.hex for the MK2250 onto the
device to implement WPA enterprise wireless security. Wireless MK2250s ship from the factory with this client
installed.
Use the Aegis Client to configure the MK2250's Spectrum24 wireless network settings. See Aegis Client
documentation for more information.

Persisting Aegis Settings

To permanently save the settings configured by the Aegis Client, run
. This creates the \Applications\Aegis.reg file containing the configured parameters.
Configuration
NOTE To deploy the same Aegis settings on multiple MK2250 devices, copy the Aegis.reg file to other MK2250
devices.
To save certificates installed on the MK2250 for use by Aegis Client, run
. This preserves the certificate across cold boot cycles.
Certificates
Using Certificates with Aegis Client
When the MK2250 is operating with the default system time after a cold boot (1st of June 1999 12:00:00 AM)
and cannot update its time over SNTP because it is not connected to the network, perform the following to use
certificates with Aegis:
Manually set the date and time.
1.
Install the certificate.
2.
Create a bat file, e.g.,
3.
date mm-dd-yyyy
time hh:mm:ss
Create a folder named
4.
Use Aegis to connect to the required network with the installed certificate.
5.
Select
6. Start > Programs > Tools > Save Certificates
to save them over power cycles.
IP Configuration of Aegis Client
The Aegis Client does not provide an interface to configure IP settings applicable for NETWLAN adapter. To
configure IP settings, on the MKMK2250, select
and set the configurations. Then select
settings over cold boot cycles.
, as follows:
SetDate.bat
in the
StartUp Application
Start > Settings > Network & Dial-up Connections > NETWLAN
Start > Programs > Tools > Save Aegis Configuration
Start > Programs > Tools > Save Aegis
Start > Programs > Tools > Save
folder, and copy this bat file to it.
and
Start > Programs > Tools > Save Aegis Configuration
to preserve the