Dell SmartStep 100N Owner's Manual page 56

HINT: You need the
Operating System CD to
®
install the Windows
operating system. You
also need the Drivers and
Utilities CD for your
computer to install the
drivers and utilities on the
new hard drive.
56
Replacing Pa rts
Turn the computer over. Use a small screwdriver to remove the hard-
7
drive screw, and place the screw in a safe location.
NOTICE: When the hard drive is not in the computer, store it in protective
antistatic packaging. See "Protecting Against Electrostatic Discharge" on
page 13.
screw
Lift up the hard-drive cover until you hear a click.
8
Slide the hard drive out of the computer.
9
Remove the new drive from its packaging.
10
Save the original packaging to use when storing or shipping the hard
drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you force
the hard drive into place using excessive force, you may damage the connector.
Slide the drive into the bay until it is fully seated in the bay. Press the
11
hard-drive cover down until you hear a click.
Replace and tighten the screw you removed in step 7.
12
Use the Operating System CD to install the operating system for your
13
computer (see page 48).
hard drive