Transducer Installation; Preparations; Installation - Eagle FishEasy 240 Portable Installation And Operation Instructions Manual

Transducer Installation

Preparations

The following shows the recommended sequence for installing the
transducer:
CAUTION:
You should read over this entire installation section before drill-
ing any holes in your vehicle or vessel!
1. Determine the approximate location for the sonar unit, so you can
plan how and where to route the cables for the transducer and power.
This will help you make sure you have enough cable length for the de-
sired configuration.
2. Determine the approximate location for the transducer and its cable
route.
3. Determine the location of your battery or other power connection,
along with the power cable route.
4. Install the transducer and route the transducer cable to the sonar
unit.
5. Route the power cable from the unit's location to an appropriate
power source and connect it there.
6. Connect the transducer/power cable to the unit and mount the sonar
unit on the bracket.

Installation

These instructions will help you install your Skimmer
transom, on a trolling motor or inside a hull. Please read all instructions
before proceeding with any installation.
Your Skimmer transducer typically comes packaged with a one-piece
stainless steel bracket for mounting it to the transom of your boat. The
5

transducer on a