Eagle Cuda 240 S/GPS Installation And Operation Instructions Manual page 31

Front view (left) and side view (right) showing dimensions of the Cuda
240 when mounted on quick release bracket.
If you wish, you can fill in the hole around the cable with a good marine
sealant compound. (Some marine dealers stock cable hole covers to con-
ceal the opening.)
This unit uses a quick release mounting bracket. When you run the ca-
ble through the hole, make sure you allow enough slack for tilting the
unit and attaching the connector. (The snug fit of the push-on water-
proof connector requires some force to attach.) Also be sure there is
enough cable slack for rotation if you decide to use the optional GBSA-3
swivel base. The swivel base lets you to rotate the sonar so it can be
seen from different parts of the boat.
Align the bracket over the cable hole with the cable slots facing away
from you and fit the cable through one of the slots. Fasten the bracket
to the dash using the three screw holes.
107.5
[4.23]
12.09 [0.48]
76.9
[3.03]
156
[6.26]
Millimeter
[Inch]
25
82.7
[3.26]
70.3
[2.77]