Sonar Simulator; Stop Chart - Eagle Cuda 240 S/GPS Installation And Operation Instructions Manual

Sonar Simulator

This unit has a built-in simulator that lets you run it as if you were on
the water. All sonar features and functions are useable. When in
simulator mode, you will see [Simulator Mode] in the Sonar Page title
bar. To use the simulator:
1. From the Sonar Page, press
2. Turn off Sonar Simulator by pressing
|
S ENT
IMULATOR
NOTE:
If you turn on your unit before attaching a transducer, it may enter a
demo mode. The words "demo mode" in a pop-up box flash in the
middle of the screen and a sonar chart plays much like the simulator.
Unlike the simulator, the demo mode is for demonstration only, and
will automatically stop as soon as you turn on the unit with a trans-
ducer attached. The simulator will continue to function normally.

Stop Chart

If you are running multiple units on a boat, there are times when you
may want to turn off the sonar. This command turns off the sonar and
stops the chart from scrolling. Sonar restarts automatically each time
you turn on your unit.
Press |↓ to
MENU
To turn on sonar and start the chart scrolling again, repeat the above step.
Digital Data/Chart
| .
EXIT
|
S C
TOP HART
|
MENU MENU
| .
ENT EXIT
61
|↓ to
S S
ONAR IMULATOR
|
MENU MENU
| .
ENT
|↓ to
S
ONAR