Eagle Cuda 240 S/GPS Installation And Operation Instructions Manual page 93

You will use the Find Waypoint commands to choose a waypoint you
want to navigate to, or to choose one for editing.
1. Press . To look up the nearest waypoint, just press
WPT
down the list to find the desired waypoint;
| . For this example, use
B N ENT
Y AME
2. If your waypoint list is a long one, you can spell out the waypoint
name in the
F
first character, then press → to move the cursor to the next character
and repeat until the name is correct, then press
below.)
3. If the list is short, you can jump directly to the
. Use ↑ or ↓ to select the waypoint name, press
pressing
ENT
the waypoint information screen appears with the
lected.
4. You can use ← or → to select various options on the waypoint informa-
tion screen. If you wanted to navigate there, just press
command is highlighted. If you want to see it on the plotter, press →
T
O
to
F O P
IND N LOTTER
Waypoint information screen on waypoint 004. Screen shows name, lati-
tude/longitude, distance to waypoint and its compass bearing. Figure at
left shows Go To command; right figure shows Find On Plotter command.
5. The Cuda 240's plotter appears, with the cross-hair cursor high-
lighting the waypoint's symbol. A pop-up name box identifies the way-
point, as well as its distance and bearing. A data box at the bottom of
the screen continues to display the location's latitude and longitude.
box to search for it. (Press ↑ or ↓ to change the
B N
IND Y AME
|ENT.
or, to look by name, press ↓ to
.
F B N
IND Y AME
87
ENT, then scroll
to jump to the list
ENT
F I L
IND N IST
command se-
G T
O O
, since the
ENT
F
IND
box by
and
ENT
G
O