Optical Drive - HP 2530p - EliteBook - Core 2 Duo 2.13 GHz Maintenance And Service Manual

Optical drive

Description
Optical drives
DVD-ROM Drive
DVD±RW and CD-RW SuperMulti Double-Layer Combo Drive
Before removing the optical drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the memory module compartment cover (see
Remove the optical drive:
1. Position the computer with the right side toward you.
2. Remove the Mylar screw cover (1) that secures the optical drive retention screw. The Mylar
screw cover is available in the Rubber Kit, spare part number 481106-001.
3. Remove the two Torx T8M2.0×5.0 screws (2) that secure the optical drive to the computer.
4. Remove the optical drive (3) from the computer.
5. If it is necessary to replace the optical drive bracket, position the optical drive with the rear
toward you.
6. Remove the two Phillips PM2.0×4.0 screws (1) that secure the optical drive bracket to the optical
drive.
60 Chapter 4 Removal and replacement procedures
Battery on page 46).
Spare part number
492558-001
492559-001
Expansion memory module on page 50).