Heat Sink - HP 2530p - EliteBook - Core 2 Duo 2.13 GHz Maintenance And Service Manual

Heat sink

Description
Heat sink (includes replacement thermal material and replacement thermal material cleaning kit)
Before removing the heat sink, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Primary hard drive (see
b. WLAN module (see
c. Optical drive (see
drive on page
d. Switch cover and keyboard (see
e. Display assembly (see
f. Top cover (see
g. System board (see
Remove the heat sink:
1. Turn the system board upside down, with the front toward you.
2. Following the 1, 2, 3, 4 sequence stamped into the heat sink, loosen the four Torx8
T8M2.0×10.0 screws (1) that secure the heat sink to the system board.
94 Chapter 4 Removal and replacement procedures
Battery on page 46).
Primary hard drive on page
WLAN module on page
Optical drive on page
67)
Switch cover and keyboard on page
Display assembly on page
Top cover on page 79)
System board on page
55)
52)
60) or Secondary hard drive (see
73)
86)
Spare part number
492582–001
Secondary hard
62)