HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual page 13

1 Installation procedures-All deployments
Installing and configuring your MSA includes the following steps, each of which is illustrated in
Figure 1 and discussed in this chapter:
• Step 1: Review and confirm your
• Step 2: Prepare your
• Step 3: Install MSA option
• Step 4: Rack the MSA and the storage
• Step 5: Install the hard
• Step 6: Prepare your
• Step 7: Install the HBA in your
• Step 8: Prepare your
• Step 9: Connect the
• Step 10: Power on the
• Step 1 1: Configure your
NOTE:
• HP recommends installing and configuring your MSA in the sequence of steps listed in this
guide. Specific dependencies exist, and if you deviate from this sequence, you may have to
uninstall and then reinstall the device.
• If a supplier is installing or configuring the MSA for you, provide them with this guide and verify
that they complete the information in "Worksheets" on page 107.
• For information about HP installing and configuring your MSA, see
page 7.
plans, page 15
site, page 28
kits, page 30
enclosures, page 31
drives, page 36
servers, page 37
servers, page 38
switches, page 39
cables, page 40
devices, page 52
MSA, page 56
HP StorageWorks 1500 Modular Smart Array installation guide
"Intended audience" on
13