Laser Compliance - HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual

Laser compliance

The SFP Module contains a laser diode of gallium aluminum arsenide (GaALAs) emitting in the
wavelength range of 770-860 nm or indium gallium arsenide phosphide (InGaAsP) emitting in the
wavelength range of 1270- 1 355 nm. All HP systems equipped with a laser device comply with safety
standards, including International Electrotechnical Commission (IEC) 825. With specific regard to
the laser, the equipment complies with laser product performance standards set by government
agencies as a Class 1 laser product. The product does not emit hazardous laser radiation.
WARNING!
specified herein or in the laser product's installation guide may result in hazardous radiation
exposure. To reduce the risk of exposure to hazardous radiation:
• Do not try to open the unit enclosure. There are no user-serviceable components inside.
• Do not operate controls, make adjustments, or perform procedures to the laser device other than
those specified herein.
• Allow only HP Authorized Service technicians to repair the unit.
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration
implemented regulations for laser products on August 2, 1976. These regulations apply to laser
products manufactured from August 1, 1976. Compliance is mandatory for products marketed in the
United States. This device is classified as a Class 1 laser product as defined by IEC 825.
Use of controls or adjustments or performance of procedures other than those
HP StorageWorks 1500 Modular Smart Array installation guide 103
This indicates that the product is classified as a
CLASS 1 LASER PRODUCT.