Setting Terminals; Figure 5.2 Idd Setting Terminals Position - Fujitsu MAN3184MC - Enterprise 18.4 GB Hard Drive Product/Maintenance Manual

5.3

Setting Terminals

A user sets up the following terminals and SCSI terminating resistor before installing the IDD in
the system as required.
•
Setting terminal:
Figures 5.2 shows the setting terminal position. Figures 5.3 shows the allocation and default
settings.
Data loss
1. The user must not change the setting of terminals not described in this
section. Do not change setting status set at factory shipment.
2. Do not change the setting of terminals except following setting pins
during the power is turned on.
•
3. To short the setting terminal, use the short plug attached when the device
is shipped from the factory.
CN2 (MP model only)
Write protect: CN2 9-10 (MP model only)
CN1
CN2
Pin 1
MAN Series (MP model only)
Figure 5.2 IDD setting terminals position
C141-E128-01EN
CAUTION
5 - 5