Table B.1 Setting Terminal: Cn2 - Fujitsu MAN3184MC - Enterprise 18.4 GB Hard Drive Product/Maintenance Manual

B.1 Setting Terminals (MP model only)
Setting item Pins
9 - 10 7 - 8
SCSI ID (Open) Open
(Open) Open
(Open) Open
(Open) Open
(Open) Short
(Open) Short
(Open) Short
(Open) Short
Short
Short
Short
Short
Short
Short
Short
Short
Write protect Open
Short
Setting item
11 - 12
Motor start mode Open
Short
Force Narrow
Force Single Ended
Terminating power
supply
* Setting at factory shipment
Note:
See the description of Section 5.3 for details of the setting requirements and notes.
B - 2
Table B.1 Setting terminal: CN2
5 - 6 3 - 4 1 - 2
Open Open SCSI ID #0
Open Short SCSI ID #1
Short Open SCSI ID #2
Short Short SCSI ID #3
Open Open SCSI ID #4
Open Short SCSI ID #5
Short Open SCSI ID #6
Short Short SCSI ID #7
Open Open Open SCSI ID #8
Open Open Short SCSI ID #9
Open Short Open SCSI ID #10 (16-bit SCSI only)
Open Short Short SCSI ID #11 (16-bit SCSI only)
Short Open Open SCSI ID #12 (16-bit SCSI only)
Short Open Short SCSI ID #13 (16-bit SCSI only)
Short Short Open SCSI ID #14 (16-bit SCSI only)
Short Short Short SCSI ID #15 (16-bit SCSI only) (*)
Write operation is enabled. (*)
Write operation is disabled.
Pins
13 - 14 15 - 16 23 - 24
Open
Short
Open
Short
Open
Short
C141-E128-01EN
Setting contents
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(Common to 8-bit and 16-bit SCSI)
(16-bit SCSI only)
(16-bit SCSI only)
Setting contents
Started by the START/STOP command
Started by turning the power supply on (*)
Width of 16 bit bus (*)
Width of 8 bit bus
Follows DIFFSNS signal level on SCSI bus (*)
Single-Ended mode
Does not supply terminating resistor power to SCSI
BUS
Supply terminating resistor power to SCSI BUS (*)