HP 353803-B22 - StorageWorks Modular Smart Array 1000 SAN Starter Installation Manual page 66
Modular smart array
Hide thumbs
Also See for 353803-B22 - StorageWorks Modular Smart Array 1000 SAN Starter:
- Maintenance and service manual (122 pages) ,
- Reference manual (48 pages) ,
- Administration manual (40 pages)
Table of Contents
Advertisement
Installing MSA-specific components on the servers
Because these installation processes involve updating the server configuration, HP recommends
performing these tasks during inactive periods.
MSA-specific components include the following:
•
HBA drivers (and multipathing tool, if needed)
•
HP System Management Homepage
•
Array Configuration Utility (ACU)
•
Array Configuration Utility - Command Line Interface (ACU-CLI)
NOTE:
If LUNs on the MSA are already being presented to the server (when performing a server
upgrade or move), disconnect the MSA from the SAN. If the MSA is unconfigured, the MSA can be
connected to the SAN.
To install these components on the server:
1.
With the HBAs installed in the server, power on the server and start up the Linux operating
system.
2.
From the console, log on as the root user.
3.
Insert the Support Software CD in the CD-ROM drive of the server.
NOTE:
CD-ROM drive of the server and do not use the shipping version of the CD. For more
information, see the following sections in this guide:
•
"Determine which version of MSA controller firmware to
•
"Obtain desired controller firmware and Support Software CD
4.
Mount the CD-ROM drive and view the contents of the CD.
5.
Locate and read the
6.
To install the HBA drivers:
CAUTION:
supported HBAs are included on the CD and are the only versions approved for use with the
MSA.
a. Navigate to the /RDP/Linux/ directory on the CD.
b. List the contents of the directory and navigate to either the Emulex or QLogic directory,
depending on the maker of your HBA.
c. Change to the CD directory for your operating system version and list the contents of the
directory.
66
Configuration procedures—Linux environments
If you created a new Support Software CD from the Web, insert that CD in the
file to review notes and information that supplement this guide.
readme.txt
Use only the Support Software CD to install the HBA drivers. Drivers for all
use" on page 15
versions" on page 54
Advertisement
Chapters
Table of Contents
