Tru64 Unix Environments; Sco Unix Environments - HP 353803-B22 - StorageWorks Modular Smart Array 1000 SAN Starter Installation Manual

If the MSA is upgraded to 7.0 or later active/active firmware,and, if you want to remove the Secure
Path for NetWare driver, do the following:
a. Follow the removal instructions provided in the Secure Path user documents.
b. From the console, enter edit c:\NWSERVER\STARTUP.NCF.
c. Comment out the following entry: #load hpqsp.cdm
d. Enter edit sys:\system\autoexec.ncf
e. Comment out the following entries:
LOAD hpqspagt.nlm
LOAD hpqspahw.nlm

Tru64 UNIX environments

• Single or dual controller configurations with active/passive firmware v4.48 are supported on
Tru64 UNIX versions V5.1A PK6 or higher.
• Dual controller configurations with active/active with firmware v7.00 are supported on Tru64
UNIX versions V5.1B PK4 or higher.
• The AlphaServer must be configured in a SAN switch zone with the MSA.
• After installing the MSA, be sure to set the host mode for each Tru64 UNIX connection to tru64.
• For information on upgrading the MSA to active/active, see the migration instructions for Tru64
UNIX environments, available on the Technical documentation page of the MSA1000 website:
http://www.hp.com/go/msa1000
• The optional embedded MSA SAN Switch 2/8 is not supported in Tru64 UNIX environments.

SCO UNIX environments

• Single controller configurations are supported with active/passive firmware only. Dual-controller
active/passive configurations are not supported.
• Dual-controller configurations must run active/active firmware.
• Detailed information about deploying an MSA in a SCO UNIX environment is provided in a
separate document available on the Technical documentation page of the MSA1000 website:
http://www.hp.com/go/msa1000
for obtaining and installing the HBA drivers for each SCO UNIX operating system.
• After installing the MSA, be sure to set the host mode for each SCO UNIX connection to linux.
.
. Included in the SCO-specific document are the procedures
HP StorageWorks 1000 Modular Smart Array installation guide 91