When Setting The Top Cover Back Into Place - Brother IntelliFax-4750 Service Manual

•

When setting the top cover back into place:

- at the right-hand side, put the speaker harness and hook switch harness* into square cutout
"X" provided in the right rear corner of the main cover. Raise the panel-main harness coming
through the main cover up and through cutout "x" provided in the top cover (through which
the hook switch harness* passes).
If the panel-main harness has been taken out from the machine, first put it into square cutout
"X" with the core-equipped end down and then raise its upper end up and through cutout "x"
provided in the top cover.
- at the left-hand side, pull up the scanner motor harness and CIS harness and raise them up
and through square and round cutouts ("y" and "z") provided in the top cover, respectively.
If the scanner motor harness or CIS harness has been taken out from the machine, first put it
into the respective cutout ("Y" or "Z") provided in the left rear corner of the main cover with
the core-equipped end down and then raise its upper end up and through the respective
cutout "y" or "z."
IV - 19
*For models equipped with a handset