Brother IntelliFax-4750 Service Manual page 124

WSW No.
WSW37
WSW38
WSW39
WSW40
WSW41
WSW42
WSW43
n n
Operating Procedure
(1) Press the 1 and 0 keys in this order in the initial stage of the maintenance mode.
The equipment displays the "WSW00" on the LCD and becomes ready to accept a firmware
switch number.
(2) Enter the desired number from the firmware switch numbers (01 through 43).
The following appears on the LCD:
(3) Use the
(4) Enter the desired number using the 0 and 1 keys.
(5) Press the Set key. This operation saves the newly entered selector values onto the EEPROM
and readies the equipment for accepting a firmware switch number.
(6) Repeat steps (2) through (5) until the modification for the desired firmware switches is
completed.
(7) Press the Set or Stop key to return the equipment to the initial stage of the maintenance
mode.
NOTES: • To cancel this operation and return the equipment to the initial stage of the
• If there is a pause of more than one minute after a single-digit number is entered for
n n
Note
The user-accessible selectors of the firmware switches are shaded in the tables given on the
following pages.
Firmware Switches (WSW01 through WSW43) Continued
Function setting 15
Function setting 16
Function setting 17
Function setting 18
Function setting 19
Function setting 20
Function setting 21
WSWXX = 0 0 0 0 0 0 0 0
and keys to move the cursor to the selector position to be modified.
maintenance mode during the above procedure, press the Stop key.
double-digit firmware switch numbers, the equipment will automatically return to the
initial stage of the maintenance mode.
Function
V - 10
Reference Page
V-47
V-48
V-49
V-50
V-51
V-52
V-53