Table of Contents
Advertisement
(6) For models available with a 2nd paper cassette: Pull the 2nd cassette relay PCB bracket to
take out its harness. Remove the screw and take off the 2nd cassette relay PCB from its
bracket.
n n
Reassembling Notes
•
Before reinstalling the high-voltage power supply PCB, push in the spring with a flat
screwdriver until it snaps into place as shown below.
•
Before reinstalling the high-voltage power supply PCB, check the high-voltage contacts for any
toner particles, paper dust or dirt, and clean them out.
Early lot machines
IV - 47
Later lot machines
Advertisement
Table of Contents
Troubleshooting
