Brother IntelliFax-4750 Service Manual page 67

n n
Reassembling Notes
• The document take-in roller and separation roller are compatible with each other. Their gears
are also compatible with each other. However, their shafts are not compatible. The document
take-in roller shaft should be a white one; the separation roller shaft should be a black one.
When setting these shaft to their rollers, fit the groove provided in each shaft over the longer
boss provided on each roller.
• When reinstalling the scanner motor, fit it in the latch provided on the scanner frame with the
connector facing up and then secure it with the screw. (See page IV-12.)
• When setting the scanner frame ASSY back into place, be sure to
- route the scanner motor harness through the hook on the top cover as shown on page IV-11
and connect it to the scanner motor,
- route the CIS harness through the hook on the top cover as shown on page IV-11 and connect
it to the CIS unit (if the CIS unit is not mounted, route the CIS harness through the left-hand
cutout provided in the scanner frame ASSY), and
- route the panel-main harness through the right-hand cutout provided in the scanner frame
ASSY.
IV - 14