Removing The Bezel - IBM x3105 - System - 4347 User Manual

Removing the bezel

When you work with some devices, such as additional optical drives, you must first
remove the bezel to access the device.
To remove the bezel, complete the following steps:
1. Remove the side cover (see "Removing the side cover" on page 19).
2. Read the safety information that begins on page v and the "Installation
3. Turn off the server and all attached devices (see "Turning off the server" on
4. From inside the server, locate the bezel release tab at the bottom of the bezel.
For instructions for replacing the bezel, see "Installing the bezel" on page 35.
20
System x3105 Type 4347: User's Guide
guidelines" on page 16.
page 12); then, disconnect all power cords and external cables.
Press the bezel release tab, and then pull the bottom of the bezel away from
the server to disengage the top bezel tabs from the server, and set the bezel
aside.
Bezel release tab