IBM 8841 - eServer xSeries 236 Installation Manual page 35

Interposer card
Mounting hole
Standoffs
a. Insert the standoffs that come with the option into the mounting holes in the
Remote Supervisor Adapter II SlimLine.
b. Align the mounting holes in the Interposer card with the standoffs; then,
align the connector on the card with the connector on the Remote
Supervisor Adapter II SlimLine.
c. Press the Interposer card and Remote Supervisor Adapter II SlimLine
together until they snap together.
4. Press the Remote Supervisor Adapter II SlimLine guide into place on the
system board.
5. Position the entire adapter assembly so that the edge connector on the
Interposer card is at the rear of the server.
6. Carefully grasp the assembly by its top edge or upper corners, and align it with
the Remote Supervisor Adapter II SlimLine guide and the connector on the
system board.
Attention: Incomplete insertion might cause damage to the system board or
the adapter.
7. Press the assembly firmly into the connector and under the retention latch on
the Remote Supervisor Adapter II SlimLine guide.
8. If you have other options to install or remove, do so now.
9. Replace the air-baffle assembly and cover. Go to "Completing the installation"
on page 22.
Connector
Standoffs Standoffs
Remote Supervisor
Adapter II SlimLine
Mounting hole
Remote Supervisor Adapter II
SlimLine
Remote Supervisor Adapter II
SlimLine guide
Remote Supervisor Adapter II
SlimLine connector
Chapter 2. Installing options
21