Connecting The Power Source; Cable Management; Computer Stand - HP 300-1020 - TouchSmart - Desktop PC Getting Started Manual

Connecting the Power Source

Route the power cord through the opening in the computer stand and plug the power cord directly into the
back of the computer. Plug the power cord into an AC power source through a surge protector/
uninterruptible power supply (UPS).

Cable Management

The HP TouchSmart PC includes an easy-to-use cable-management feature; all cables connected at the back
of the computer are routed through the opening in the computer stand.

Computer Stand

The HP TouchSmart PC is shipped with the computer stand secured against the back of the computer. To
assure that the computer is in a stable position on your desktop, pull the computer stand open. Then, if you
want to change the angle of the HP TouchSmart PC, hold each side of the computer and tilt it back to an
angle of between 5 degrees and 40 degrees from the vertical.
CAUTION: Make sure the angle of the computer is at least 5 degrees from the vertical;
otherwise the computer will be unstable and could fall over.
CAUTION: The computer stand stays in place as you increase the angle; the computer moves
forward. Take care that the computer screen does not move off the table.
5° min.
40°
max
Welcome
9