Using The Access Control List - 3Com 3CRWE675075 - 11a/b/g Wireless LAN Workgroup Bridge User Manual

Using the Access
Downloaded from www.Manualslib.com
You can use the Access Control List to allow or prohibit access to the
Control List wireless network from Ethernet clients.
Follow these steps to build the Access Control List:
1 Under System Configuration, click Access Control List.
2 On the Access Control List page, click Add.
The Access Control List New ACL page appears.
3 On the New ACL page, enter the MAC address of the client you want to
add to the Access Control List, select the permission type, and click the
Add button to substantially add it.
4 Repeat steps 2 and 3 for each client.
5 Select the System Default Mode:
Allow—allows the client to access the Bridge.
■
Deny—prohibits the client from accessing the Bridge.
■
CAUTION: With the Allow option of the System Default Mode selected,
the Bridge allows all Ethernet frames except those carrying the
MAC addresses that are specified in the Access Control List and have the
permission type Deny. Similarly, with the Deny option of the System
Default Mode selected, the Bridge denies all Ethernet frames except
those carrying the MAC addresses that are specified in the Access Control
List and have the permission type Allow.
Make sure that the MAC address of the computer through which you are
configuring the Bridge is not specified in the Access Control List with the
permission type Deny if you want to set the access control type to Allow.
If you want to set the Access Control Type to Deny, make sure that the
MAC address of the computer is included in the Access Control List with
the permission type Allow. Failure to do so results in access to the Bridge
being blocked; the Bridge will no longer be configurable through the
computer.
6 Click Apply.
To delete one or more than one client(s) from the Access Control List,
select the client(s) and then click Delete.
manuals search engine
Using the Configuration Management System 39