Hitachi C10FSB - 10 Inch Sliding Dual Bevel Compound Miter Saw Safety & Instruction Manual page 24

English
Fence
(3) Setting to cut crown moldings at positions 1 and 4 in Fig. 36 (see Fig. 42; tilt the head to the right):
1 Turn the turntable to the right and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the upper surface (B in Fig. 35) contacts the fence as indicated
Fig. 44.
(4) Setting to cut crown moldings at positions 2 and 3 in Fig. 36 (see Fig. 43; tilt the head to the right):
1 Turn the turntable to the left and set the Miter Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
2 Tilt the head to the right and set the Bevel Angle as follows:
* For 45° type crown moldings:
* For 38° type crown moldings:
3 Position the crown molding so that the lower surface (A in Fig. 35) contacts the fence as in Fig. 45.
Head
4
Miter Angle
Scale
Cutting method of crown molding without tilting the saw blade.
Crown molding Vise Ass'y
(optional accessories)
6mm Knob
Bolt
6mm Knob Bolt
Crown molding Stopper (L)
6mm Wing Bolt
(optional accessories)
Fig. 46-a
24
A
B
Table on Base
Fig. 40
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
35.3° ( mark)
31.6° ( mark)
30° ( mark)
33.9° ( mark)
Bevel Angle Scale
1
Fence
Base
Turntable
Fig. 42
Fence
A
B
Table on Base
Fig. 44
Crown molding Stopper (R)
(1) Crown molding Stopper (L) and (R) (optional accessories) allow
(optional accessories)
Fence
B
Head
3
Fence
Turntable
Fence
A
easier cuts of crown molding without tilting the saw blade.
Install them in the base both-sides side to be shown in Fig. 46-
a. After inserting Tighten the 6mm knob bolts to secure the
crown molding Stoppers.
[Optional accessories used]
• Crown molding Vise Ass'y (Include Crown molding Stopper
(L))
• Crown molding Stopper (L)
• Crown molding Stopper (R)
A
Table on Base
Fig. 41
Bevel Angle Scale
2
Base
Miter Angle
Scale
Fig. 43
B
Table on Base
Fig. 45