Hitachi C10FSB - 10 Inch Sliding Dual Bevel Compound Miter Saw Safety & Instruction Manual page 14

English
Gear Case
Saw Blade
Turntable
Base
Fig. 10-a
8mm Depth
Adjustment Bolt
Loosen
Gear Case
Fig. 10-b
4. Lower limit position of saw blade when cutting a large workpiece
NOTE:
When cutting a workpiece exceeding 3-11/32" (85mm) in height in right-angle cutting or 2-3/
16"(55mm) in left bevel angle cutting or 1-3/16" (30mm) in right bevel angle cutting, adjust
the lower limit position so that the base of the motor head (see Fig. 10-a) will not come in
contact with the workpiece.
To adjust the lower limit position of the saw blade, follow the procedures (1) to (3) shown in Fig. 10-a.
(1) Loosen the 8mm wing nut so that the 8mm depth adjustment bolt can be turned by hand.
(2) Lower the motor head, and thrun the 8mm depth adjustment bolt by hand and make adjustments
so that there can be a clearance of 3/32" to 1/8" (2mm to 3mm) between the lower limit position of
the motor head and the top of the workpiece at the saw blade's lower limit position (where the head
of the 8mm depth adjustment bolt contacts the gear case.
(3) After adjustment, turn the 8mm wing nut until it contacts the Hinge (see Fig. 10-b), and fully tighten
it.
5. Confirmation for use of sub fence
WARNING:
Left bevel angle cutting
Turn
Sub Fence
Fence (B)
Fig. 11
14
(1) Loosen the 8mm wing nut.
8mm Wing Nut
(2) Insert your 6mm hexagon bar wrench from behind of the tool
(3) Turn the 8mm depth adjustment bolt, change the height where
8mm Depth
Adjustment
Bolt
(4) Turn the 8mm hexagon socket set screw to the right (clockwise)
8mm Hexagon Socket
Set Screw
Turn
Hinge
8mm Wing Nut
In the case of left bevel cutting, turn the sub fence counterclockwise. Unless it is
turned counterclockwise, the main body or saw blade may contact the sub fence,
resulting in an injury.
This power tool is Equipped with a sub fence.
Right bevel angle cutting
Direct angle cutting
In the case of direct angle cutting and right bevel angle cutting, use
the sub fence. Then, you can realize stable cutting of the material
with a wide back face.
In the case of left bevel cutting, raise the sub fence up as illustrated
in Fig. 11 and then turn it counterclockwise.
and turn the 8mm hexagon socket set screw to the left
(counterclockwise) as viewed from behind of the tool.
the bolt head and the gear case contacts, and adjust the lower
limit position of the saw blade. One turn of the 8mm depth
adjustment bolt changes the lower limit position of the saw
blade by about 5/16"(8mm), and this information can be used
as a rough guide.
as viewed from behind of the tool, and let it softly contact the
tip of the 8mm depth adjustment bolt.