Hitachi C10FSB - 10 Inch Sliding Dual Bevel Compound Miter Saw Safety & Instruction Manual page 16

English
10. Confirmation for use of sub fence (A)...(Optional accessory)
Sub Fence
(A)
6mm Knob
Bolt
Fig. 15
11. Using an ink line
Saw Blade
Groove
Guard
Workpiece
Fig. 16
6mm Knob Bolt
Move the
Guard
Backward
Fence (B)
Fig. 17
CAUTION:
12. Position adjustment of laser line (Only Model C10FSH)
WARNING:
16
In the case of direct angle cutting and angle cutting, use the sub
fence (A). The sub fence (A) can be installed on the right side of the
guide fence. Insert the rods of the sub fence (A) into the holes in
the guide fence. Tighten the 6mm knob bolt which come with the
sub fence (A) to secure the sub fence (A). Then, you can realize
stable cutting of the material with a wide back face.
(1) Right angle cutting
6mm
Knob Bolt
Marking
(pre-marked)
(2) Miter cutting and compound cutting
Safety
Cover
Marking
(pre-marekd)
In some arrangements when the turntable is rotated, the guard projects from the
fence surface. Loosen the 6mm knob bolt and push the guard to the retracted position.
Never lift the safety cover while the saw blade is rotating. When cutting at an angle
of 35° to the right or more, please slide the guard to the rear.
The guard and sub-fence will not only make contact and adversely affect cutting
accuracy, this could also result in damage to the guard.
* Make sure before plugging the power plug into the receptacle that the main body
and the laser marker are turned off.
* Exercise utmost caution in handling a switch trigger for the position adjustment of
the laser line, as the power plug is plugged into the receptacle during operation.
If the switch trigger is pulled inadvertently, the saw blade can rotate and result in
unexpected accidents.
* Do not remove the laser marker to be used for other purposes.
WARNING:
In the case of right bevel cutting, remove the sub
fence (A). Supposing it is not able to remove it,
It will contact the blade or some part of the tool,
causing in serious injury to operator.
Loosen the 6mm knob bolt and contact the tip of the guard
with the workpiece.
Aligning the ink line on the workpiece with the groove of the
guard, the workpiece is cut on the ink line (Fig. 16).
(Miter cutting + bevel cutting)
Upon lowering the motor section, the safety cover is raised and
the saw blade appears.
Align the ink line with the saw blade (Fig. 17).