Hitachi C10FSB - 10 Inch Sliding Dual Bevel Compound Miter Saw Safety & Instruction Manual page 20

English
WARNING:
4. Cutting narrow workpieces (Press cutting)
Hinge
Holder (A)
Fig. 28
5. Cutting large workpieces
Auxiliary
Board
6mm Nut
Fence
Fig. 29
6. Cutting wide workpieces (Slide cutting)
1 Pull Forward
3 Push Rearward to Cut
Workpiece
Fig. 30
20
* Confirm that the trigger switch is turned OFF and the power plug has been removed
from the receptacle whenever the tool is not in use.
* Always remove the lock-off button from the handle and store it in a secure place
after completing the work.
* Always turn the power off and let the saw blade stop completely before raising the
handle from the workpiece.
If the handle is raised while the saw blade is still rotating, the cut-off piece may
become jammed against the saw blade causing fragments to scatter about
dangerously.
* Every time one cutting or deep-cutting operation is finished, turn the switch off,
and check that the saw blade has stopped. Then raise the handle, and return it to
the full retract position.
* Be absolutely sure to remove the cut material from the top of the turntable, and
then proceed to the next step.
* Continued cutting operation can result in overload of the motor. Touch the motor
and if it's hot, stop your cutting operation once and rest for 10 minutes or so, and
then restart your cutting operation.
Slide the hinge down to holder (A), then tighten the slide securing
Handle
knob (see Fig. 2) as indicated in Fig. 28.
Lower the handle to cut the workpiece.
Using the power tool this way will permit cutting of workpieces of
Press
Down up to 3-11/32" (85mm) square.
Workpiece
There may be case when a complete cutting cannot be done
depending on the height of workpiece. In this case, mount an
6mm Flad Hd.
Screw
auxiliary board with the 6mm flat head screws and the 6mm nuts
using the 7mm holes on the fence surface (two holes on each side).
(Fig. 29)
Refer to page 9 "SPECIFICATIONS" for the thickness of the auxiliry
board.
(1) Workpieces up to 3-11/32" (85mm) high and 12-9/32" (312mm) wide:
Loosen the slide securing knob (see Fig. 2), grip the handle and
Handle
slide the saw blade forward.
Then press down on the handle and slide the saw blade back to
cut the workpiece as indicated in Fig. 30. This facilitates cutting
of workpieces of up to 3-11/32" (85mm) in height and 12-9/32"
2 Press (312mm) in width.
Down
(2) Workpieces up to 3-9/16" (90mm) high and 11" (280mm) wide:
Workpieces of up to 3-35/64" (90mm) in height and up to 11"
(280mm) in width can be cut in the same manner as described
in paragraph 6-(1) above.