Editing Organ Flutes Parameters
The Organ Flute Voices selected from the [ORGAN FLUTES] button can be edited by adjusting the footage
levers, adding the attack sound, applying effect and equalizer, etc.
After editing, go to the Voice Selection display by pressing the [I] (PRESETS) button and save the setting. The settings will be lost if you
select another Voice or turn the power to the instrument off without executing the Save operation.
■ FOOTAGE Page
Refer to the Owner's Manual, chapter 2.
■ VOLUME/ATTACK Page
4', 2 2/3', 2'
■ EFFECT/EQ Page
Same parameters as in the VOICE SET "EFFECT/EQ" Page explained on
Same as the
Adjusts the overall volume of the Organ Flutes. The longer the graphic
bar, the greater the volume.
Affects both the attack and release
increasing or decreasing the response time of the initial swell and release,
based on the FOOTAGE controls. The higher the value, the slower the
swell and release.
Determines the speed of the vibrato effect controlled by the Vibrato On/
Off ([F]/[G] buttons) and Vibrato Depth ([H] button).
The MODE control selects between two modes: FIRST and EACH. In the
FIRST mode, attack (percussive sound) is applied only to the ﬁrst notes
played and held simultaneously; while the ﬁrst notes are held, any subse-
quently played notes have no attack applied. In the EACH mode, attack is
applied equally to all notes.
These determine the attack sound volume of the ORGAN FLUTE Voice.
The 4', 2-2/3' and 2' controls increase or reduce the volume of attack
sound at the corresponding footages. The longer the graphic bar, the
greater the attack sound volume.
Affects the attack portion of the sound producing a longer or shorter
decay immediately after the initial attack. The longer the graphic bar, the
longer the decay.
12) portion of the sound,
CVP-509/505/503/501 Reference Manual