Displays - Yamaha 503 Reference Manual

■ EFFECT/EQ Page
1 REVERB DEPTH/CHORUS DEPTH/DSP DEPTH/VIB ROTOR
[1 ▲▼]/
REVERB
[2 ▲▼]
DEPTH
[3 ▲▼]/
CHORUS
[4 ▲▼]
DEPTH
[5 ▲▼]
DSP ON/OFF
[6 ▲▼]
DSP DEPTH
[7 ▲▼]
VIBE ROTOR
2 DSP
[1 ▲▼]–
DSP TYPE
[4 ▲▼]
[5 ▲▼]–
VARIATION
[8 ▲▼]
[5 ▲▼]
ON/OFF
PARAMETER
[6 ▲▼]
VALUE
–[8 ▲▼]
3 EQ
Determines the Frequency and Gain of the Low and High EQ bands. For information about EQ, refer to
page 74.
■ HARMONY Page
Harmony sets the Right 1 and 2 parts together. Select the Right 1 part in the Main display, before you set
it. This has the same settings as the display of "Selecting the Harmony/Echo type"
Adjusts the reverb depth.
Adjusts the chorus depth.
Determines whether the DSP is on or off.
Adjusts the DSP depth.
If you want to re-select the DSP type, you can do so in the "2 DSP"
menu explained below.
This will be displayed only if VIBE VIBRATE is selected for the DSP
Type parameter explained below. Determines whether VIBE
VIBRATE should be set to on or off when selecting the Voice.
Selects the DSP effect category and type. Select a type after selecting a
category.
Two variations are provided for each DSP type. Here, you can edit the
VARIATION on/off status and variation's parameter value setting.
The factory-programmed assignments are set to variation-off for all
Voices (standard variation of DSP is assigned). If you select VARIA-
TION ON here, a variation of the DSP effect is assigned to the Voice.
The variation parameter value can be adjusted in the VALUE menu
explained below.
Displays the variation parameter. (This differs depending on the effect
type and cannot be changed.)
Adjusts the value of the DSP variation parameter.
CVP-509/505/503/501 Reference Manual
page 5 in step 3.
2
13