Tandberg Data DLT-V4 Product Specification page 46

FCC Notices (U.S. Only)
Product Manual Statements for Class B Equipment
(Tabletop Tape Drive)
DLT-V4 Product Specification
Product Manual Statements for Class B Equipment (Tabletop Tape Drive)
• Part 8 - Power frequency magnetic field Requirements
• Part 11 - Voltage dips, short interruptions and voltage variations
Requirements
• EN 55022: 1998, +A1: 2000, +A2: 2003 Class B/CISPR 22: 1997, +A1:
2000, +A2: 2003 Class B, "Limits and Methods of Measurement of
Radio Disturbance Characteristics of Information Technology
Equipment."
The following standards only apply to the tabletop tape drive:
• EN 61000-3-2: 2000, Limits for harmonic current emissions
(equipment input) current up to and including 16A per phase
• EN 61000-3-3: 2001, Limitation of voltage fluctuations and flicker in
low-voltage supply systems for equipment with rated current up to
and including 16A.
This device complies with Part 15 of the FCC Rules. Operation is subject
1
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more, of the following
measures:
Appendix A Regulatory Statements
1
34