Table of Contents
Advertisement
LAN Phone 101 User Manual Guide
Chapter 2 Operating Procedure – LCD Display Configuration
1.Initialize LAN Phone 101
1. When power on the LAN Phone 101, the LCD screen shows as below.
2. Wait around one minute until the LAN Phone 101 finishes boot program initialization.
3. User can see flashing greeting as below:
System Initializing..............
4. Then LAN Phone get into standby mode:
GK
The main LCD screen would be shown as similar as above. The GK word means the LAN
Phone 101 is in GateKeeper Mode, and when LAN Phone is connected to SNTP server, on
LCD will show current time from SNTP server.
5. After pressing the PSTN button, the GK word will be replaced by PSTN. Then LAN Phone
is in PSTN Mode. Please notice that in PSTN mode user must plug PSTN line in RJ-11 port.
PSTN
Press or to enter configuration mode then press OK Bottom to enter certain menu.
There are 6 selections for configuration.
1.
System Configuration (mandatory, protected by password)
2.
User Line Number (mandatory)
3.
Ring Configuration
4.
Indicate Forward Type
5.
Message Box
6.
Phone Address Book
Copyright (c) 2003 WellTech Computer Corporation
IP-Phone
Board Start Booting
IP-Phone
10:10:10 AM
IP-Phone
10:10:10 AM
12
LAN Phone Ver. 114/504(Normal and PPPoE)
Document Ver. 1.8b
Advertisement
Table of Contents
