Chapter 2 Operating Procedure - Lcd Display Configuration; Initialize Lan Phone 101 - WELLTECH LAN PHONE 101 H.323 Manual

LAN Phone 101 User Manual Guide
Chapter 2 Operating Procedure – LCD Display Configuration

1.Initialize LAN Phone 101

1. When power on the LAN Phone 101, the LCD screen shows as below.
2. Wait around one minute until the LAN Phone 101 finishes application program
initialization.
3. User can see flashing greeting as below:
4. Then LAN Phone get into standby mode:
GK
The main LCD screen would be shown as similar as above. The GK word means the LAN
Phone 101 is in GateKeeper Mode, and when LAN Phone is connected to SNTP server, on
LCD will show current time from SNTP server.
5. After pressing the PSTN button, the GK word will be replaced by PSTN. Then LAN Phone
is in PSTN Mode. Please notice that in PSTN mode user must plug PSTN line in RJ-11 port.
PSTN
Press  or  to enter into Configuration Mode and then press OK Bottom.
There are ten selections for configuration.
1. Quick Setup(mandatory)
2. Connect Configuration (mandatory)
Copyright (c) 2002 WellTech Computer Corporation
Lan Phone
System initializing
Have a Nice Day
IP-Phone
10:10:10 AM
IP-Phone
10:10:10 AM
11
Document Ver. 1.5
LAN Phone Ver 109
Release 2002/06/07