Sysconf] Command - WELLTECH LAN PHONE 101 H.323 - VERSION 114 & 504 Manual

Table of Contents

LAN Phone 101 User Manual Guide

12.[sysconf] command

This command displays the system information and configuration.

1. -print: display system overall information and configuration.

2. -plan: It is for setting dial numbering plan. While e164 number is three digits, the plan

should be set as 3 or 0. The plan 0 is for any positive digits use.

3. –callalive: Enable or disable auto-disconnection after 10 seconds not receiving packets from

remote party(sysconf –callalive 0/1, 0 for disable and 1 for enable)

4.-keypad:set DTMF type .User can select DTMF type LAN Phone receive and

transmit.(sysconf –keypad 0/1/2/3 , 0 for inband ,1 for H.245 alphanumeric, 2 for H.245

signal type, 3 for Q.931 user info, 4 for RFC2833.)

5.-idto:set the duration(in second) of two pressed digits in dial mode as timed out. If after the

duration user hasn't pressed next number, LAN Phone will dial out all number pressed.

6.-eod:select end of dialing key, e.g set end of dial key as OK button , after finished pressing

dialing number then press OK will dial out. (sysconf –eod 0/1/2/3 , 0 for no end of dial key ,

1 for "OK" button , 2 for "#" button , 3 for "＊" button )

7.-h450:Enable or disable H.450 related features, which include transfer, hold and forward.

LAN Phone Ver. 114/504(Normal and PPPoE)

Document Ver. 1.8b

Table of Contents

Lan phone 101