H323] Command - WELLTECH LAN PHONE 101 H.323 - VERSION 112 & 502 Manual

Ip-based telephone system

Table of Contents

LAN Phone 101 User Manual Guide

4.-keypad:set DTMF type .User can select DTMF type LAN Phone receive and

transmit.(sysconf –keypad 0/1/2/3 , 0 for inband ,1 for H.245 alphanumeric, 2 for H.245

signal type, 3 for Q.931 user info, 4 for RFC2833.)

5.-idto:set the duration(in second) of two pressed digits in dial mode as timed out. If after the

duration user hasn't pressed next number, LAN Phone will dial out all number pressed.

6.-eod:select end of dialing key, e.g set end of dial key as OK button , after finished pressing

dialing number then press OK will dial out. (sysconf –eod 0/1/2/3 , 0 for no end of dial key ,

1 for "OK" button , 2 for "#" button , 3 for "＊" button )

7.-h450:Enable or disable H.450 related features, which include transfer, hold and forward.

12. [h323] command

1. –print: display H.323 stack information and configuration.

2. –mode: configure LAN Phone 101 as GateKeeper or Peer-to-Peer Mode.

Usage:h323 –mode 0/1(0 for GateKeeper mode ,1 for Peer-to-Peer mode)

3. –gk: set Main GateKeeper IP address(h323 –gk "xxx.xxx.xxx.xxx")

4. –algk:set IP address alternative GateKeeper. If LAN Phone tries to register to main

GateKeeper for 10 times but still fail, LAN Phone will try to register to alternative

GateKeeper.

5. –e164: identify one number for the LAN Phone 101 to register to the GateKeeper

(h323 –e164 "X").

6. –e164-x:user can assign other 10 telephone numbers .For example, 10 users share the same

LAN Phone, they can assign phone numbers as 100, 200, 300....(h323 –e164 100 –e164-1

200 –e164-2 300....) User can disable one number and the number after this one. Ex. from

set 1-5 is configured, if user set the third number as "x", from third to fifth number will be

LAN Phone Ver. 112/502(Normal and PPPoE)

Document Ver. 1.7

Table of Contents

Lan phone 101