Changing The Headlight Bulbs - MOTO GUZZI NORGE 1200 Manual

CAUTION
Before changing a bulb, move the
ignition switch to position "
wait a few minutes, so that the bulb
cools down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the
bulb, as this may lead to overheating
and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
NOTE
Before changing a bulb, check
the fuses, see page 85 (CHANGING THE
FUSES).
CHANGING THE HEADLIGHT
BULBS
Carefully read page 88 (BULBS).
" and
The headlight houses:
√ two low beam bulbs (upper) (1);
√ two high beam bulbs (lower) (2);
√ two parking light bulbs (lower) (3);
To change oil:
Place the vehicle on the stand, see page
u
60 (PUTTING THE VEHICLE ON THE
STAND).
Move aside the dash panel, see page
u
48 (LIFTING THE DASH PANEL).
1
2
3
HIGH BEAM BULB (2)
Do not pull on the wires to extract the
bulb connector.
u
u
u
NOTE
holder, making sure to match the locating
slots.
u
u
u
6
5
4
Remove the rubber protection (4).
Disconnect the connectors (5).
Release the two ends of the retainer (6)
and remove the bulb, fit a new one
having the same rating, see page 96
(TECHNICAL DATA).
Insert the bulb into the bulb
Refit the bulb in its seat and lock it in
place using the retainer (6).
Connect connectors (5) and refit the
rubber protection (4).
Install the dash panel.
use and maintenance Norge 1200
4
89