Changing The Headlight Bulbs - MOTO GUZZI BREVA V1100 Manual

CAUTION
Before changing a bulb, move the
ignition switch to position "
wait a few minutes, so that the bulb
cools down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the
bulb, as this may lead to overheating
and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
NOTE
Before changing a bulb, check
the fuses, see page 79 (CHANGING THE
FUSES).
1
CHANGING THE HEADLIGHT
BULBS
Carefully read page 82 (BULBS).
" and
The headlight houses:
√ one high beam bulb (lower).
√ one low beam bulb (upper);
√ one parking light bulb (lower);
To change oil:
Place the vehicle on the stand, see page
u
55 (PUTTING THE VEHICLE ON THE
STAND).
Applies to high and low beam bulbs only.
Remove the two side screws (1) to remove
u
the headlight.
Remove the cover (2), push it up, release
u
it from lower tab and slide out the top tang
from its seat.
2
3
HIGH BEAM BULB
Do not pull on the wires to extract the
bulb connector.
Disconnect the connector (3).
u
Turn the ring nut counter clockwise and
u
remove the bulb body (4).
Change with a new one.
u
Refit the bulb body in the housing and
u
turn clockwise until it locks in place.
Connect the connector (3).
u
use and maintenance Breva
5 6
4
83