Changing The Headlight Bulbs - MOTO GUZZI 2005 Griso 1100 Use And Maintenance Book

CAUTION
Before proceeding to change a bulb, set
the ignition switch to "
some time for the bulb to cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the
bulb, as this may lead to overheating
and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
NOTE
Before changing a bulb, check
the fuses, see page 73 (CHANGING THE
FUSES).
76
use and maintenance Griso
CHANGING THE HEADLIGHT
BULBS
Carefully read page 75 (BULBS).
" and allow
The headlight houses:
√ one low/high beam bulb (1) (upper);
√ one parking light bulb (2) (lower).
To change oil:
Place the vehicle on the stand, see page
u
50 (PUTTING THE VEHICLE ON THE
STAND).
To remove the complete reflector from
u
headlight body, loosen the screw (3).
4
3 7
1
5
LOW/HIGH BEAM BULB
Do not pull on the wires to extract the
bulb connector.
Grasp the bulb connector (4) and pull to
u
disconnect it from the bulb.
Slip off the dust cover (5) with your
u
fingers.
Unhook the two ends of the retaining
u
spring (6) positioned on the bulb holder.
Extract the bulb (1) from its seat.
u
NOTE
Insert the bulb into the bulb
holder, making sure to match the locating
slots.
Fit a new bulb of equal rating.
u
6