MOTO GUZZI NORGE 1200 Manual page 20

TIMING
To turn on the TIMING:
confirm selection on TIMING by pressing
u
the selector (1) for several seconds.
The display will show the actual value and
the previous three values stored. To the
left of the value is the lap number.
To start the timing:
Briefly press the selector (1).
u
If you press the selector (1) again within
the first 10 seconds from when the timer
starts recording, the lap timer will reset.
After 10 seconds, if you push it again, the
data will be stored and the next lap timer
will start recording.
20
use and maintenance Norge 1200
Press the selector (1) for several seconds
to cancel the lap timer session. The
counter on the display is reset. Briefly
press the selector (1) to restart the
session.
To go back to LAP TIMER:
Press the selector (1) for several
u
seconds.
NOTE
40 is the maximum number of
sessions that can be recorded, further data
can be stored only if the previous set is
deleted.
Data acquisition stops when key is turned
off. When key is turned back on, although
the display will not be set to LAP TIMER
function the data are stored in the memory,
therefore the following data acquired will
follow the previous sessions stored.
Stored data will be lost if battery is
disconnected.
VIEW TIMES
This function also displays the acquired lap
times.
To enable VIEW TIMES option:
Confirm selection on "VIEW TIMES" by
u
pressing the selector (1) for several
seconds.
To scroll the pages:
Briefly press the selector (1).
u
To go back to LAP TIMER:
Press the selector (1) for several
u
seconds.
DELETE TIMES
This function deletes the acquired lap
times.
To delete data:
press the selector (1) for several
u
seconds.
Data deletion is to be confirmed.
Once done, the display will go back to LAP
TIMER function.