Controls On The Dash Panel - MOTO GUZZI NORGE 1200 Manual

CAUTION
With the engine stopped and the switch
in position " ", the battery may wear
down.
With vehicle stopped, stop the engine and
leave switch set to position " ".
7) HAZARD SWITCH ( )
Press it to activate all turn indicators.
This func tion can be enabled or
disabled only if ignition switch is set to
position " ". Once activated, the turn
indicators stay on even if key is turned
off. To disable them, set ignition switch
to " ".
28
use and maintenance Norge 1200
1

CONTROLS ON THE DASH PANEL

NOTE
The electric components only
operate when the ignition switch is in the
" " position.
1) ABS DISABLING SWITCH
Disable the system as follows:
Take the ignition switch to "
u
the engine. It is recommended to disable
the ABS while engine is running, with
vehicle stopped.
Press and hold the SET (1) push-button
u
for several seconds.
After about three seconds the light on
the instrument panel will start blinking.
Immediately release push-button (1).
u
Now the ABS light on the panel will carry
u
on blinking slowly meaning that the ABS
is completely disabled.
Re-enable the ABS as follows:
Stop the vehicle and the engine setting
u
the ignition switch to "
Take the ignition switch back to ≈
u
start the engine.
With engine running, the ABS will be re-
u
enabled when speed gets above 5 km/h.
NOTE
In case of failure or when ABS is
disabled, the motorcycle acts as if it is not
equipped with this system.
" and start
".
≈ and