MOTO GUZZI NORGE 1200 Manual page 22

To set the Gear shift indicator threshold:
Briefly press the selector (1) to increase
u
threshold value by 100 rpm at a time. As
soon as the value reaches the maximum
limit, it is decreased by the same amount
if the selector (1) is pressed again.
To store the set threshold and go back to
SETTINGS function:
press the selector (1) for several
u
seconds.
The set value is stored until it is set again.
NOTE
When the threshold is exceeded,
the red light in the rev counter flashes; take
engine rpm below threshold value and the
red light should go off.
BACK LIGHTING
This function allows the user to adjust the
lighting power of the instrument panel.
To enter the BACK LIGHTING function:
Confirm selection on BACK LIGHTING
u
by pressing the selector (1) for several
seconds.
The display shows three levels for lighting
intensity:
√ LOW
√ MEAN
√ HIGH
Levels can be selected in a sequence by
briefly pressing the selector (1).
To store the set level and go back to
SETTINGS function:
press the selector (1) for several
u
seconds.
22
use and maintenance Norge 1200
°C/°F
This function allows you to select the unit
of measurement for ambient temperature.
To enter the °C/°F function:
Confirm selection on °C/°F by pressing
u
the selector (1) for several seconds.
T h e d i s p l a y s h o w s t w o u n i t s o f
measurement:
√ °C
√ °F
Units of measurement can be selected in a
sequence by briefly pressing the selector
(1).
To store the selected range and go back to
SETTINGS function:
press the selector (1) for several
u
seconds.
KM/MILES
This function allows you to select the unit
of measurement for speed.
To enter the "KM/MILES" function:
Confirm selection on "KM/MILES" by
u
pressing the selector (1) for several
seconds.
T h e d i s p l a y s h o w s t w o u n i t s o f
measurement:
√ KM
√ MILES
Units of measurement can be selected in a
sequence by briefly pressing the selector
(1).
To store the set unit and go back to
SETTINGS function:
press the selector (1) for several
u
seconds.
12H/24H
This function allows you to select the time
format.
To enter the 12H/24H function:
Confirm selection on "12H/24H" by
u
pressing the selector (1) for several
seconds.
The display shows two formats:
√ 12H
√ 24H
The formats can be selected by briefly
pressing selector (1).
To store the chosen format and go back to
SETTINGS function:
press the selector (1) for several
u
seconds.
IMMOBILIZER LED
This function allows you to enable/disable
the alarm led flashing inside the fuel level
gauge indicator.
It is used in case an external antitheft
system is connected to the vehicle.
CHANGE THE CODE
Allows the user to change his personal
code. During the procedure the user is
prompted to enter the old code.