MOTO GUZZI BREVA V1100 Manual page 20

SETTINGS
This function allows you to set and
customise the layout of the parameters to
be displayed for the various configurations.
To enter the SETTINGS function:
Confirm selection on SETTINGS by
u
pressing the SET (2) push-button for
several seconds.
The display will show the following options:
√ EXIT
√ TIME SETTINGS
√ GEAR SHIFT INDICATOR
√ BACK LIGHTING
√ °C/°F
√ KM/MILES
√ 12H/24H
√ IMMOBILIZER LED
√ CHANGE THE CODE
Options can be selected in a sequence by
briefly pressing the SET(2) push-button.
20
use and maintenance Breva
TIME SETTINGS
This function allows you to set the clock.
To enter the TIME SETTINGS function:
u Confirm selection on TIME SETTINGS
by pressing the SET (2) push-button for
several seconds.
To set the hour value:
Briefly press the SET (2) push-button to
u
increase hour value that is increased by
one unit every time the push-button is
pressed.
Press the SET (2) push-button for
u
several seconds to shift to minute
setting; press it briefly to increase value,
value is increased by one unit every time
the push-button is pressed.
To store the set data and go back to
SETTINGS function:
press the SET (2) push-button for
u
several seconds.
GEAR SHIFT INDICATOR
This function allows you to set the value for
the Gear shift indicator threshold.
To enter the GEAR SHIFT INDICATOR
function:
Confirm selection on GEAR SHIFT
u
INDICATOR by pressing the SET (2)
push-button for several seconds.
The display shows "Gear shift indicator"
and the rev counter scale indicates the
threshold value currently set.
To set the Gear shift indicator threshold:
Briefly press the SET (2) push-button to
u
increase threshold value by 100 rpm at a
time. As soon as the value reaches the
maximum limit, it is decreased by the
same amount if the SET (2) push-button
is pressed again.
To store the set threshold and go back to
SETTINGS function:
press the SET (2) push-button for
u
several seconds.
The set value is stored until it is set again.
NOTE
When the threshold is exceeded,
the red light in the rev counter flashes; take
engine rpm below threshold value and the
red light should go off.
BACK LIGHTING
This function allows the user to adjust the
lighting power of the instrument panel.
To enter the BACK LIGHTING function:
Confirm selection on BACK LIGHTING
u
by pressing the SET (2) push-button for
several seconds.
The display shows three levels for lighting
intensity:
√ LOW
√ MEAN
√ HIGH
Levels can be selected in a sequence by
briefly pressing the SET(2) push-button.